We provide commercial roof repair services in North Platte for flat, metal, leaking, and industrial roofs, starting each job with an inspection.
Our commercial roof repair services in North Platte, grouped by the roof or problem each one handles.
Built for low-slope TPO, EPDM, built-up, and modified bitumen roofs on storefronts, offices, and warehouses. Repairs cover split laps, blisters, failed base flashing, cracked drains, and the low spots where water sits after storms.
Typical Repairs
Exposed-fastener and standing-seam roofs on fleet shops, ranch supply buildings, and steel warehouses get backed-out screws replaced, end and side laps resealed, ridge cap reset, and rust-through panels swapped for matching sheets.
Typical Repairs
When you know there is a leak but not where it starts. Tracing runs from the stain inside to the entry point on the roof, using moisture meters, water tests, and infrared on large roofs.
Typical Repairs
Plants and rail-service warehouses with exhaust fans, process vents, skylights, and expansion joints get repairs made from above, planned with the plant manager so the floor below keeps working.
Typical Repairs
Find the condition you see, then read across to the service that usually handles it. Many buildings need two, and one inspection covers both.
| Roof Condition | Flat Roof | Metal Roof | Leak Tracing | Industrial |
|---|---|---|---|---|
| Water standing after stormsLow spots and slow drains. | Usually Fits | Rarely | Sometimes | Sometimes |
| Drips under a row of screwsWashers and fasteners failing. | Rarely | Usually Fits | Sometimes | Rarely |
| Stain with no clear sourceWater traveling along the deck. | Sometimes | Sometimes | Usually Fits | Sometimes |
| Membrane soft near a fanGrease or heat damage. | Sometimes | Rarely | Sometimes | Usually Fits |
| Rust holes in a few sheetsPanels thin along the laps. | Rarely | Usually Fits | Rarely | Sometimes |
| Blisters on a built-up roofPlies lifting in clusters. | Usually Fits | Rarely | Rarely | Sometimes |
Describe what the roof is doing and where water shows up. The inspection sorts it into the right service.
The four steps stay the same across all four services. Only the repairs in step three change.
Call or send the address, the roof type if you know it, and where water shows up inside. We set a time that works around your tenants or shifts, and confirm how we reach the roof.
The roof gets walked, every seam and penetration checked, and moisture readings taken near each problem so the repair size is clear before pricing. Interior stains get matched to the roof areas above them.
TPO gets welded, EPDM taped, built-up roofs plied, and metal panels refastened or replaced, each with material that bonds to what is already there. Drains and curbs get reflashed in the same pass.
Photos of every repair and a list of anything left for later go to you, so the next budget starts from facts. Repaired drains are flow-checked and seams probed before we leave.
Answers to what owners ask when they are unsure which service they need.
Mixed Roofs
Yes. Many shops have a metal roof over the bays and a low-slope roof over the office, and both get inspected on the same walk. The joint where the two roofs meet gets a close look, since it is a frequent leak point.
Repairs for each section use the right material for it: welded or taped membrane on the flat part, and fasteners and butyl tape on the metal.
Leak Tracing
That is the most common reason owners call. Tell us where the stain or drip shows up inside, and leak tracing starts there.
We follow the water upslope on the roof and confirm the entry point with moisture readings or a water test before any repair goes down. The repair then falls under whichever service fits that spot.
Timing
As soon as you can schedule it. Each storm through an open seam or boot soaks more insulation, and wet boards add cost to the repair.
Until the visit, keep stock out of the drip line and note when the water appears, which helps the tracing go faster. A few phone photos of the stain also help.
Cost
The same drivers apply: the roof system, the number and size of problem areas, wet insulation, and access.
Plant roofs add rooftop equipment to work around, hot work permits, and sometimes a short fan shutdown, so planning time becomes part of the scope. Larger roofs can also need lifts to move material.
Phasing
Yes. The inspection ranks problem areas by leak risk, so the worst ones get repaired first and the rest wait for the next budget.
Each phase leaves the roof watertight, and the photo record shows what changed between visits. That record also helps when you present the next phase for approval.
Occupied Buildings
Yes, nearly every repair happens over an open business. Noisy or hot work gets scheduled around tenants and shifts.
Areas under the repair get protected, and access for lifts and ladders is agreed on with the property manager beforehand. Tenants get notice of rooftop work above their space.
Drains
Flat roof repair covers it. The drain gets cleared, the strainer and clamping ring checked or replaced, and the membrane resealed into the bowl.
If debris keeps collecting, tapered boards around the drain and a better strainer help water reach the opening faster. Overhanging trees or nearby gravel ballast are worth checking as the source.
Send the address and a few words about the roof, and we will set up the inspection.
